MYTEMPOWALK
  • Home
  • Set Up
  • Launch
  • Maintenance & Warranty
  • Common Problems
  • Training Videos
  • Resources

Ultrasonic Sensors - Training Video Library

Sensor Replacement Guide

Sensor System Disabled

  1. The sensor disabled alert will be triggered at power up. If a single sensor trips 3 times in 30 mins or any combination of sensors trip 5 times in 30 minutes. (Note: This may also be caused by a towel or head cover hanging in front of the sensors or by inexperienced users repeatedly turning towards the unit while they are still connected to the Tempo Walk).
  2. Begin with a visual inspection of all 3 sensors on the front of the Tempo Walk. You should look for scratches and pressed in center sensors as a sign of damage. Sensors showing this damage should be replaced immediately. See the sensor replacement guide below for instructions on how to do this.
  3. ​Finally, after you complete the sensor replacement, power ON the Tempo Walk, wait 2 seconds after the audible alert finishes, and then press the neutral button 2 times to reset this alert. You will hear a beep to confirm the reset. ​

Course Setup

Program Launch

Maintenance

Troubleshooting

Resources

Copyright © 2020
  • Home
  • Set Up
  • Launch
  • Maintenance & Warranty
  • Common Problems
  • Training Videos
  • Resources